PDA

View Full Version : Closed Case & PSU for SAM440 + Radeon 9250 PCI graphics card



Ericgb1
23rd May 2012, 23:33
Hi after case and power supply for Sam 440 ep and also Radom 9250 pci graphics card but must be 3.3 volts well that what manuals say also but of newbie with s stuff so any advice on car power supply be helpful

Tajmaster
23rd May 2012, 23:44
I use this case for my SAM:

http://www.cclonline.com/product/58948/CSCITS010BA/Cases/CiT-S010BA-Black-Slim-Micro-ATX-Tower/CAS0421/

Mines well built and compact and looks great. It has quite a small foot print so you can lug it about if you please or put it in small spaces normal cases wouldnt fit.

Bare in mind that you will need to use low profile cards with the case above.

Regarding the 9250, Your SAM has a 33Mhz PCI slot so you may not see the benefit of using it. This is not my experience however, its just what Ive read.

Have a look at this thread that I put up on Amigans.net :

http://www.amigans.net/modules/xforum/viewtopic.php?forum=25&topic_id=5203&post_id=0&start=0&move=0&mode=0&type=0&order=ASC

I have a SAM 440 Flex, which is a little newer than your SAM but some of the comments on that thread relate to your SAM :)

piacc64
24th May 2012, 08:30
i have the radeon, but not tested, i need exclude the vga on board on sam440ep for test

20 plus p&p paypal fee

Tajmaster
5th June 2012, 08:36
i have the radeon, but not tested, i need exclude the vga on board on sam440ep for test

20 plus p&p paypal fee

Has a trade been completed here?

piacc64
5th June 2012, 13:01
i not tested the vga at the moment, no contact with buyer