I'm looking for working (not shorted) head from a bad 1541 drive to my good drive with bad head. I can use two pieces as I have two drives.
You can measure resistance with a multimeter on the head as you can see on the attached picture: 25-35ohm between red/blue lines, 10-15ohm between black/yellow lines on a good head. You don't have to disassembly the whole drive to check, remove only top case.
Thank you guys.
You can measure resistance with a multimeter on the head as you can see on the attached picture: 25-35ohm between red/blue lines, 10-15ohm between black/yellow lines on a good head. You don't have to disassembly the whole drive to check, remove only top case.
Thank you guys.
Attachments
Last edited: