Found broken 64 main board and small bits

Status
Not open for further replies.

rkauer

Amiga fanboy
Rating - 100%
109   0   0
Joined
Dec 17, 2007
Posts
10,337
Country
Brazil
Region
São Leopoldo, RS
Nothing fancy! Just want the joystick+switch+PSU and fascia for a project.

A replacement (working) character ROM is a plus!

If someone also have that switch used in the ill-fated CUSA x86 inside a C64-like case I want a couple or two of those. :)
 
Will PM you later. Bed time.:tired:

Oh, the switch that suits me is the red (and green) PS0001. Perfect for a reset hack in C64's keeping the original look. ;-)

Picture:
 
Last edited:
Found these 2 for you , which do you want?

Rest in PM.
 

Attachments

  • 271202510482_1.jpg
    271202510482_1.jpg
    3.8 KB · Views: 0
  • 271202510671_1.jpg
    271202510671_1.jpg
    4.2 KB · Views: 0
Doesn't seem like the ones I'm looking for. But I'll take the one in the left to not waste your time any longer.

The one I'm looking for is the very same used in the ill fated CUSA 64 clone. Almost the same as this image, but in red.

Please PM me the total costs.:)
 

Attachments

  • ps001.jpg
    ps001.jpg
    2.5 KB · Views: 0
PS001-N11NAWURXX-W50-1.jpg


http://www.mouser.com/ProductDetail...=sGAEpiMZZMvxtGF7dlGNpkU5JbWfF14M25xayFKnJ9c=

I have become pretty good at searching Mouser for specific items. ;)
 
Yeh i know mouser, ther company is 25 km from me. But if i order something i have to pay 20 euro postage because the button comes from US.
 
As said before, will take Marco's red chromed button (no jokes, please). Does it fits on the normal hole where the C64 LED usually goes (same diameter)?

Also, do you have any surplus PLA for C64?
 
As said before, will take Marco's red chromed button (no jokes, please). Does it fits on the normal hole where the C64 LED usually goes (same diameter)?

Also, do you have any surplus PLA for C64?


i dont think that button is anywhere near the same diameter as the original led.
i think the smallest one ive seen is 16mm hole cut out for it.
 
Then only the ps001 model will fit. Sigh, here goes part of my project. :-(

Marco, the other parts will do. :)
 
Status
Not open for further replies.
Back
Top Bottom