Closed nano SwinSID HC (High Compatibility)

Status
Not open for further replies.
CodeKiller

CodeKiller

New member
Rating - 100%
5   0   0
Joined
Dec 14, 2014
Posts
48
Country
Hungary
Region
Nógrád
Discontinued!! Look forward for the new revision! (Currently in testing phase)

old Update: Temporally out of stock --- new revision in the development!
----------------------------------------------------------------------------------


After a lot of development, I have managed to squeeze more compatibility into the nanoSwinSID. (sorry, the fw is not public at the moment)

Thanks to Nobody @ forum64.de and Swallow of Censor Design for helping the project!


Now it support almost everything but the read only registers and ext-in.

It knows everything the other versions knows and more:
- gate bit trigger support (some music switches the gate bit off only for a few C64 cycle to start a new note)
- gate bit trigger support when more register updated after the gate start
- full 12 bit support for voice's PWM
- test bit trigger support for the new, high quality PWM effect
- full 4 bit master volume
- 44kHz 8 bit sample playback ($D418 trick)

front.JPGback.JPG

(the actual ones are cut strait, it's just the first prototype)

Comparing the different versions:



There are multiple pieces available.
Each one is tested before shipping.

The price is € 16.00 + paypal fee + shipping

Shipping cost for up to about 10 pieces:
- Hungary registered - € 2.00
 - Hungary not registered - € 1.00

- World Wide International registered/tracked - € 5.00


Please support the real developers!

--------------------------
Some people wondered about the jumper settings so here it is:

If you hold the board vertically as the pin 1 is up-left
- upper (blue) jumper - close if installed in motherboards designed for 8580 / open if installed in place of 6581 (output attenuator)
- lower (red) jumper - close for 6581 mode filter / open for 8580 mode filter
 
Last edited:
Time to part with some money... :)
I'll PM you right away (but it appears I need two posts under my belt as a new user to be able to send PM's, so I better find something else
to reply to first... :cool: ).
 
Sorry, this version does not support reading from SID -- no paddles and no osc3/env3. (there is a work in progress version but needs more time to properly develop it)
 
Hi,

I would like to purchase one unit, destination is Germany.
Is this possible?

Thanks
 
I am intrested. It looks like we allready spoke on the Forum64 site together (same nick as here) please update me also, when paddle support is implemented. Than i gonna order more.

Thanks,

Anton
 
adtbm said:
I am intrested. It looks like we allready spoke on the Forum64 site together (same nick as here) please update me also, when paddle support is implemented. Than i gonna order more.

Thanks,

Anton
Click to expand...

Payment received, Thank you! I will send it on Monday.


Well, the ADC will take some time as the new PCB still not ready (not even the design/layout finished yet).

I will update the progress in the Forum64 topic.
 
Status
Not open for further replies.
Back
Top Bottom