With all credit given to Lallafa http://lallafa.de/blog/amiga-projects/plipbox/ Awesome job.
He didn't want to make the main PCB that is used to connect the Plipbox to the Amiga's parallel port so I did. For any and all technical question, see the above link.
The Arduino Nano is programmed with the 0.6 firmware. The power plug is 2.1mm center pin for 5 volts center positive. You need to supply your own 5 volt PSU
I am asking $40 plus ship via Paypal.
I have 12 more units tested and ready to go.
I want to thank every one who have supported my project and all the great feedback I've been getting.
These are the NEW units above, I can't seem to get any more of the Ethernet adapters with the LONG PINS.
UPDATE: The US Postal service just increased shipping rates, For a small flat rate box in the US was $5.25 it is now $6.80 and for international it was $25.25 it is now $33.95 for most of the world. These rates are out of my control sadly.
He didn't want to make the main PCB that is used to connect the Plipbox to the Amiga's parallel port so I did. For any and all technical question, see the above link.
The Arduino Nano is programmed with the 0.6 firmware. The power plug is 2.1mm center pin for 5 volts center positive. You need to supply your own 5 volt PSU
I am asking $40 plus ship via Paypal.
I have 12 more units tested and ready to go.
I want to thank every one who have supported my project and all the great feedback I've been getting.
These are the NEW units above, I can't seem to get any more of the Ethernet adapters with the LONG PINS.
UPDATE: The US Postal service just increased shipping rates, For a small flat rate box in the US was $5.25 it is now $6.80 and for international it was $25.25 it is now $33.95 for most of the world. These rates are out of my control sadly.
Last edited: