Sold Atari MegaST internal IDE Adapter

Status
Not open for further replies.

HuskyTE

Member
Rating - 100%
17   0   0
Joined
Nov 20, 2014
Posts
110
Country
Spain
Region
Barcelona
Hi,

here I offer two different revisions of the Atari MegaST internal IDE adapter by ppera.

One for 40pin IDE and another for 44pin IDE

MegaST IDE 40pin c.jpg
MegaST IDE 44pin c.jpg

They are solder-less. Only two cables needed, and they're only inserted on pins available at the motherboard of the MegaST.
Those cables are included, as the flat cable for the 44pin version.
Those adapters aren't auto-booting. You need a patched 1.04, 2.06 or boot from floppy.
In not auto-booting, hddriver of ppera's work fine.
If you want auto-booting, apart from Tos, you'll need ppera's drivers.

Hi, I have several adapters available.

40€ shipping included to Europe.
45€ shipping included to US and Canada.

Best regards,
Jordi.

Advertised elsewhere!
 
Last edited:
[h=2][/h]
Declaring interest for 40pin version, sending PM. If 44pin version will not be taken by Hempsa I will be next in line.
 
Hi,
there is where you have to connect Acsi10 cable:
ACSI10.jpg
And where you see the yellow cables, any point of that two, is valid for placing your Vcc cable:
Vcc.jpg
 
Status
Not open for further replies.
Back
Top Bottom