Hello Guys,
For sale are 3 of my ready built Zorro-IDE-LAN-CP Multifuction Cards which provide the following features in one card:
IDE Part (Oktagon 2008 clone) with one connector, which provides Power for CF Card adapters if connected.
LAN Part based on Microchip ENC624J chip, ZorroII or ZorroIII support depending on loaded firmware.
Clockport compatible connector to support hardware built for beeing connected to an A1200 ClockPort connector.
The IDE and Clockport connectors are always Zorro II devices but the LAN part is able to be ZorroII or ZorroIII depending on firmware.
I Have done tests with the cards in various Amigas like: CB A1000, A4000d, AA3000+(from Hese), A4000 TX (from Hese) and it worked like a charm.
The ZorroII Firmware version works in all ZorroII or ZorroIII Machines. The ZorroIII Firmware version only works in ZorroIII Machines.
I can put the firmware to the device as requested from buyer.
There is no Card left for sale.
I'm Asking 125€ per piece plus shipping for the card with soldered RJ45 Module on the base board (see Pictures)
or
140€ per piece plus shipping for the card with external RJ45 Module connected through 20 cm ribbon cable. (see Pictures)
Payment via Paypal to friends.
If you have any questions, do not hesitate to ask!
For sale are 3 of my ready built Zorro-IDE-LAN-CP Multifuction Cards which provide the following features in one card:
IDE Part (Oktagon 2008 clone) with one connector, which provides Power for CF Card adapters if connected.
LAN Part based on Microchip ENC624J chip, ZorroII or ZorroIII support depending on loaded firmware.
Clockport compatible connector to support hardware built for beeing connected to an A1200 ClockPort connector.
The IDE and Clockport connectors are always Zorro II devices but the LAN part is able to be ZorroII or ZorroIII depending on firmware.
I Have done tests with the cards in various Amigas like: CB A1000, A4000d, AA3000+(from Hese), A4000 TX (from Hese) and it worked like a charm.
The ZorroII Firmware version works in all ZorroII or ZorroIII Machines. The ZorroIII Firmware version only works in ZorroIII Machines.
I can put the firmware to the device as requested from buyer.
There is no Card left for sale.
I'm Asking 125€ per piece plus shipping for the card with soldered RJ45 Module on the base board (see Pictures)
or
140€ per piece plus shipping for the card with external RJ45 Module connected through 20 cm ribbon cable. (see Pictures)
Payment via Paypal to friends.
If you have any questions, do not hesitate to ask!
Attachments
Last edited: