Support Gotek AMIGA 1200 printed in 3D

Status
Not open for further replies.
I might be intersted in a white one for the A600. But not until thy end of the year. Will you still be making these come January?

Sent from my SM-G900F using Tapatalk
 
Got my two cradles today, well packaged and printed. Feedback being posted now
 
Hi have you finished your design with 0.91inch oled display yet and if so will be making a1200 and a500 mounts?
 
I am interested in one of these for an A600, should I go ahead with buying a gotek instead of a floppy drive for it. Do I have to buy a gotek, disassemble it and fit the internals into this adapter? Also, do you have any instructions or a video showing how I go about fitting this? Just be nice so I can see what I would be doing, should I get one.
 
could I have an a1200 mount with the oled window?

pm interest for a1200 with oled and a500 oled

Payment sent
 
Last edited:
I am interested in one of these for an A600, should I go ahead with buying a gotek instead of a floppy drive for it. Do I have to buy a gotek, disassemble it and fit the internals into this adapter? Also, do you have any instructions or a video showing how I go about fitting this? Just be nice so I can see what I would be doing, should I get one.

remeber to flash your gotek drive with flash floppy first or hxc
 
Status
Not open for further replies.
Back
Top Bottom