dejavu4u2
Member
I assume you've removed the clock board of your SX-64 because you wanted to convert it from PAL to NTSC or because there was a problem with the board present.
However, please note I do not recommend using LumaTOLB on the SX-64 because of the way the VIC-II is cooled. The heat sink is rather large and that's perfectly normal and LumaTOLB slides under this IC and elevates it even further possibly causing physical conflicts or short circuits. I don't recommend using a smaller heat sink.
The reason for wanting to use LumaTOLB is because the 8.182MHz crystal is faulty and I've found them to be very much unobtainium.
Very good point regarding the heatsink. Yes, that's likely to cause problems I hadn't considered. Will have to look at alternatives.
Thanks!
Last edited: