Hi all, so i bought one of MKL's IDE+8MB boards that sit in the 68000 slot.
I have installed this board into a CDTV and took the OVR & INT2 signals from Gary & a CIA chip. After a bit of confusion i now have it detecting my hdd and i can choose to boot from it in the early start menu. It begins to boot but eventually reboots to a software failure error.
I am assuming this is because its running out of ram while attempting to boot into ClassicWB 68K.
The 8mb ram does not autoconfig on the CDTV and so i am now stuck.
Can anyone break down what i need to install/edit/add to get the ram available?
Thanks for any assistance
I have installed this board into a CDTV and took the OVR & INT2 signals from Gary & a CIA chip. After a bit of confusion i now have it detecting my hdd and i can choose to boot from it in the early start menu. It begins to boot but eventually reboots to a software failure error.
I am assuming this is because its running out of ram while attempting to boot into ClassicWB 68K.
The 8mb ram does not autoconfig on the CDTV and so i am now stuck.
Can anyone break down what i need to install/edit/add to get the ram available?
Thanks for any assistance
