https://www.ebay.com/itm/128pins-PG...705812?hash=item3a5174b394:g:N20AAMXQOQdRHohc
I'll check and see if I have a spare. If I do, its all yours for the cost of shipping. PM me.
- - - Updated - - -
I found most of the missing parts on Ebay and Mouser. Just went searching for the backordered parts on Mouser and found acceptable replacements. The big issue was that I had to buy lots of 100 for some of the parts when I ordered them off Ebay. I have extras all over the place. I will do an inventory in the next week to see what extra parts I have. I found the Trimmer pot (R26) but it was only 3 pole. If you look at the board, the 3 holes to the left of the trimmer pot are all connected together so a 3 pole should work. The 1-5pF (C59) and 5-40pF (C80) were found on Ebay and shipped from Bulgaria.
I have not been able to program the Lattice chip yet. Still waiting to hear from someone in regards to how to program the Lattice chip. I can make the adaptor, but I lack the proper software to actually write the chip.
I'll check and see if I have a spare. If I do, its all yours for the cost of shipping. PM me.
- - - Updated - - -
I found most of the missing parts on Ebay and Mouser. Just went searching for the backordered parts on Mouser and found acceptable replacements. The big issue was that I had to buy lots of 100 for some of the parts when I ordered them off Ebay. I have extras all over the place. I will do an inventory in the next week to see what extra parts I have. I found the Trimmer pot (R26) but it was only 3 pole. If you look at the board, the 3 holes to the left of the trimmer pot are all connected together so a 3 pole should work. The 1-5pF (C59) and 5-40pF (C80) were found on Ebay and shipped from Bulgaria.
I have not been able to program the Lattice chip yet. Still waiting to hear from someone in regards to how to program the Lattice chip. I can make the adaptor, but I lack the proper software to actually write the chip.
Last edited: