So, if you guys have been following the development of this case in the General section of the board, you'll have noticed that it's now finished and ready to go.
If you missed it, along with all the pictures and even a short video, here's the link: http://www.lemon64.com/forum/viewtopic.php?t=59181.
I'm now making these cases available for sale.
Schema Wifi Modem Case : $40.00 USD
Microview Programmer Case : $10.00 USD
Canada & US Airmail Shipping : $10.95 USD
Outside US/Canada Airmail Shipping : $12.95 USD
Available colors are as follows:
Black
White
Red
Orange
Green
Silver
Yellow
Beige
Transparent Filament (add $5.00 USD to your order for this filament)
You may also have a different lid variant that allows access to be Microview breakout connector at the top of the board.
If you're interested in one, send me a message telling me what you'd like, the color, lid type and your shipping address. I'll then send you my paypal details.
Thanks to everyone who's been supporting my Commodore 3D printing efforts.
Thomas
COREi64
If you missed it, along with all the pictures and even a short video, here's the link: http://www.lemon64.com/forum/viewtopic.php?t=59181.
I'm now making these cases available for sale.
Schema Wifi Modem Case : $40.00 USD
Microview Programmer Case : $10.00 USD
Canada & US Airmail Shipping : $10.95 USD
Outside US/Canada Airmail Shipping : $12.95 USD
Available colors are as follows:
Black
White
Red
Orange
Green
Silver
Yellow
Beige
Transparent Filament (add $5.00 USD to your order for this filament)
You may also have a different lid variant that allows access to be Microview breakout connector at the top of the board.
If you're interested in one, send me a message telling me what you'd like, the color, lid type and your shipping address. I'll then send you my paypal details.
Thanks to everyone who's been supporting my Commodore 3D printing efforts.
Thomas
COREi64
Last edited: