Recent content by Drgonzo

Declaring interest. One TF360 without CPU, but with riser. (Marked as sold/completed by alenppc)

Greetings, I'm running into some strange video tearing/discoloration on my Amiga 1200 display and was hoping someone might have seen this before and could point me in the right direction. It comes and goes, moves around, etc... Sometimes it seems like after warming up it's better, but then...

Exchange and transaction complete. Thanks again! ��

PM sent to arrange payment. G

Declaring interest. 2nd in line.

Arrived today, installed, and all seems well. Thanks! Feedback on the way as soon as I figure out how to do it. :D ~G

PM received, PM sent, payment sent. Thanks much! ~G

Expressing interest in a TF330 card, no riser, and no CF. Thank you G

Ok, so actually pulled some strings and got a rev 6 68060RC50, dropped it in, and sure as **** it does seem more stable. Everything I'd read (or thought I'd read) was around the 006 being good at overclocking and preferable, but had thought earlier revs would at least function... and in theory...

I tried installing the MMULib from Aminet, but each time I try a fresh install it renders the machine unbootable with some strange message on boot about a string being too long and it just stops dead at a cli prompt. I did a little chasing down through the startup sequence but wasn't able to...

Apologies, but withdrawn. Regards, G

Resurrecting an old thread as I've moved the needle a bit. I have a patched 3.1 Kickstart now but have been struggling to get things stable. If I go back to a clean load with the 040 then all works fine. With the 060 I can boot but get software errors of varying degrees based on the several...

Yup, not sure if it's ok to link to Amazon here, but the site says the manufacture # is 6922621500827. If you paste that in it should take you right to the unit I bought. The only other thing I did was flash the latest firmware on it before using. 1.2 I think? Hope that helps. -G

Can't say with absolute certainty as I only played a bit of AB2 and I don't know that it uses all the buttons even if mapped. However, I was able to shoot, walk backwards, and bring up the mission info (or whatever it is) so at least three buttons of the ABXY worked great. I'll have to dig a...

I can confirm it works if you put an Ebay Genesis -> CD32 adapter in line. The 8bitdo Genesis dongle arrived from Amazon today, plugged it in via the aforementioned adapter, and I'm now gaming with multiple buttons on my SNES style 8bitdo controller. Interestingly enough, without the adaptor...