Recent content by Mandarancino

I have a questionbut can anyone tell me if the ability to manage multi-uploads has been more implemented at the software level?

So,with the buzzer I can not if it is passive but it is in the kit so i deduce be well welded with red on + but it does not work! As for the method I described you, I just tried it but when I do Re-Play the file does not start walking and the LED does not turn green, maybe there's something...

I have 2 question: How come my buzzer does not make any noise ?? Do you have to enable it in the scketch before sending it to arduino or is there anything else I can control? When a TAP loads a level of a game and then eventually needs to load the second, is it not handled by the pause? I...

HI, I just finished my Tapuino put in a shell of an original datasette, hope you like it! https://www.facebook.com/media/set/?set=a.10212858465197335.1073741833.1260473662&type=1&l=e9c7a17b66 and the video https://www.youtube.com/watch?v=VC4t5FTpMFQ&t=15s

Ok but for the LCD 1602 There are two possible addresses According to the power supply i2c on board, my i2c address is 0x3F and not 0x27 add this possibility on config-user.h.example??

@Staple_nutz I still have to connect to c64, I have purchased a broken datasette and I want to integrate everything inside so I use the keys of the original datasette! @sweetlilmre I still miss the explanation that not all I2c respond to the same address, the original your config only has...

I Solved the Issue looking on internet, The problem was simple as complicated: In the config-user-h at the firt voice of LCD is #define LCD_USE_1602_LCD_MODULE #define LCD_I2C_ADDR 0x27 // I2C address for the LCD The address 0x27 is not universal, I purchased the LCD already...

I had followed this photo to connect the lcd to the nano directly! I flash the arduino after commenting on the 2 lines of the lcd and the language, set arduino nano, atmega328 and the com port is 3, the arduino when i launch the flash starts blinking with red led but i did not get results...

The integrated are both in the right direction, I do not know if there is a way to control the arduino so many times that was the problem !! Hope that spcbm know how to help me .. !! @EDIT: I did another test by excluding the spcbm PCB and connecting the lcd directly to the arduino nano by...

i 4 fili sono ok, collegati correttamente, per il piccolo integrato,non avendo scritte visibili (spalidite) e nessun segno, per non sapere ne leggere ne scrivere l'ho messo in entrambe le posizioni per provare ma non cambia niente!!

I have already rotated the potentiometer behind the lcd power supply but I have disappeared all or just see the squares as in the photo, how I understand they have to appear for a while and then disappear when it loads the arduin software but it does not seem to load anything! I have also...

I was wrong, I see the LCD but I do not see it written, I just see squares full on the top row.

Hi! I just assembled the Tapuino, downloaded the folder to program it, connected it, compiled the .sh file as an explanation and flashed the arduino but I can not see anything on the video, the LCD remains without any writing !! Where can I get wrong? I checked the components and the welds...

Thank you very much for the very complete explanation, in fact my doubt was to see if the program to flash x the tapuino also worked with different models seen these small changes! Now I do not have to buy a specific model!

Hi, Some can explain why in Arduino nano,some write CH340G and more CH340? Is the same part? and some write ATmega328 and some write ATmega328P? it's different??