Recent content by teevee

Seems same with 27C160, I bought 10 of these and all of them seems faulty: http://www.ebay.com/itm/280732997704 In the guide for this adaptor is also written, that V should be set to 12.5V. I will try run my 27C160 through a cleaner/eraser and try with 200 US pulse delay setting too :) <...

The downgrading from 6.60 to 6.50 was easier, than expected. Thanks for the links. I had 10 of these: Ebay Link I was able to program 6 of the 10 eproms, while 4 of them seemed faulty. It starts programming and stops after 25-40 % in the process with a error. I asked seller and seller said...

Thanks Viktor/DjCook, Do you use the new firmware or the older 6.5? :)

I want to be able to burn 27C160 and 27C800 again :D

I have problems with 27C128 and 27C64 in version 6.60 where a error pops after 25 % and the work-around here is to choose 27128 and 2764 instead (without C), which is absurd because it is another revision of the same model :picard

Hi DJCook, thank you for the reply. I have not experienced any issue with the older revision of the firmware. The nice about the new one is the new implemented IC support (example M27C128A in my case), but I still feel that the former version 6.50 was better. It would be nice if you can...

Thank you for the reply. The manual is not very good structured. Can you pin-point me and did you experience a similar issue as I?

I experience problems with this board after minipro forced me to update to 6.60 on the software version

Thank you for the update/confirmation :thumbsup:

Money sent off :)

nice

I would also like to buy one if you still have them in stock :D - - - Updated - - - Check your PM