Recent content by timmie

So does that mean, no it doesn't support all CD32 buttons?

Bump

Pricedrop

I'll just consider buying a new one then, or just don't bother with disabling it. I meant, I bought mine from you I believe :) But I totally understand you won't give me a free replacement. You're not a business.

That would be you IIRC :D

And I noticed my flash command did not have the :w at the end? Would that have been an issue?

Unfortunately, even after reflowing the pinheader solderjoints, it still doesn't work. The jumper definately shorts the two pins. Enable works fine. Disable still gives black screen. Is that the same behaviour a TF330 gives without the proper firmware? So would something have gone wrong with...

Sorry to be so stupid and naggy. Two left pins are disable = red vertical line connecting two right pins in my drawing (of upside down card)?

OK, but what is the disable and what is the enable position?

So I did connect correctly? I wasn't sure what was top in your message, oriented in relation to text on PCB or to CD32. Yes, on-off-on. So what would be what? On: TF330 enabled (Splash screen when no HDD) Off: ? On TF330 disabled (Splash screen) I'll test with a jumper first (Although I tested...

OK, I managed to flash the card. I think it was successful, see picture. However, with the switch connected as in the other picture, I just get a black screen in one position and a working TF330 in the other position. Positions of the switch all the way to the left and all the way to the right...

On which three pins exactly should this go and which pin must be the middle one of the switch?

Another pricedrop

Pricedrop

Yes I understand, I thought the reaction was a bit harsh though, for something that felt like an extra gesture of still adding the ownership proof while not needed. Corrected them now, hope their fine like this.