Printable View
Is there a wiki on how to record from datasette? I have a boxed 1.5 using the latest version of the software. I've checked that the tapes load on my C64. I set the invert to 1. Start the record and when the tape stops I press the stop/abort button on the Tapuino but none of the Taps work when I play them back.
Was it so that invert needs to be 0, when recording from tape to tap and 1, when recording from tap to tape?
Quote:
Originally Posted by protek
I'll give it a try.
EDIT: Invert 0 creates a blank file. Invert 1 creates a file but it doesn't load properly.
I have the PCB 1.7 (updated to 1.71) of Tapuino and it works fine in this way:Quote:
Originally Posted by Buleste
Datassette to Tapuino
- Tapuino option invert = 1
- Tapuino record (auto or manual)
- Datassette play
- At the end of the program must be stopped manually Tapuino
Tapuino to Datassette
- Tapuino option invert = 1
- Datassette record
- Tapuino play
- Commodore is only turned on (no play or record)
----------------------------------------------------------- EDIT updating ------------------------------------
I think that for version 1.5 of PCB at least should be able to record from the Commodore to the Tapuino in this way:
- Tapuino option invert = 1
- Tapuino record (auto or manual)
- Commodore save
IMPORTANT: You must remember to set option invert = 0 before you (re)load a program from Tapuino to Commodore!
----------------------------------------------------------- Last updating --------------------------------------
You are right ...
Even I can not save from the Commodore into Tapuino-memorySD: empty file.
I always record from C64 to Tapuino with invert = 0.Quote:
Originally Posted by c64new
Thanks also to Quagliarulo I can write this wiki-tapuino-pedia :) to record, duplicate, load with Tapuino PCB 'base', PCB 1.5, PCB 1.71.
--------------------------------------------------------------->
About RECORDING
Datassette to Tapuino
- Tapuino option invert = 1
- Tapuino record (auto or manual)
- Datassette play
- At the end of the program must be stopped manually Tapuino
Tapuino to Datassette
- Tapuino option invert = 1
- Datassette record
- Tapuino play
- At the end of the program must be stopped manually Datassette
- N.B.: Commodore is only turned on (no play or record)
Commodore to Tapuino
Tapuino option invert = 0
- Commodore save
- Tapuino record
- N.B.: At the end of the program the recording on the microSD stop automatically
About LOADING
IMPORTANT: You must remember to set option invert = 0 before you (re)load a program from Tapuino to Commodore!
------------------------------------------------------------------------->
I hope it's liked this little reminder and I would appreciate if others can contribute or hotfix this small guide ... and also my not good English :lol:
Thanks for your submission I have updated the FAQ in the Wiki accordingly.
-(e)
That is what I've been doing but the resulting TAP file doesn't load correctly.Quote:
Originally Posted by c64new
Does the tape work correctly from Datassette to C64? If not, you could have a misaligned R/W head or a bad tape. Also check that the SD card is fast enough and the level conversion circuit is suited (that is, not made of just resistors). Also consider that recording accuracy isn't perfect yet.Quote:
Originally Posted by Buleste
Tape works fine from Datasette to C64. It may be the SDcard though. I'll check on it's speed.