Amstrad CM14 To Amiga?

I have a Amstrad CM14 Monitor that I want to use with an Amiga 600.
I have been looking on line for the last hour to see if there is a cable diagram which will allow me to do this but have had no luck.
Does anyone here have this monitor connected to their amiga?

give me a sec and ill look at mine...

i also think fitzsteve has a setup like this.

EDIT:fitxsteve dont have the exact monitor,ill look at the service manual for your monitor and find the pinouts:)..back in a few.

EDIT2,this does look doable.ill be back a bit(maybe an hour or so)after a hot drink,and ill make schematic you can read:)
basically,you need to connect these signals to the monitor:red,green,blue,composite sync and ground for the video then right,left and ground for the audio and your away...

Thanks Roy be great if you can get me the correct pinouts from the amiga to the CM14

here you go.:) please excuse the crudeness of drawing it was done in a hurry,lol
http://www.amibay.com/attachment.php...1&d=1420416678

if anyone else knows different please comment:)

Excellent work Roy....now if you could find me a CM14 monitor and ship it to Athens i would be your no1 fan!:lol:

:lol:

Thanks again Roy I will try to put a cable together this week and let you know how it goes.

Does the last line say and add 10 to ground?

Quote:

---

Originally Posted by roy_bates

here you go.:) please excuse the crudeness of drawing it was done in a hurry,lol
http://www.amibay.com/attachment.php...1&d=1420416678

if anyone else knows different please comment:)

---

Hey, is that "RoyCAD 10.3" you've used there? :D

Bryce.

Quote:

---

Originally Posted by dallyis

Thanks again Roy I will try to put a cable together this week and let you know how it goes.

Does the last line say and add 10 to ground?

---

no mate,its supposed to say "audio ground"

also,be aware this is the pinouts as you look at the socket on the amiga and plug on the monitor OR the solder side of the connectors as you make the cable:)
here is a tip for you when you build the cable,connect the audio from the amiga inside the hood of the 23 pin d type plug,that way you only have one cable going to the monitor.
p.s you only actually need a 7 core cable OR a 6 core screened cable going to the monitor connector.

best of luck.

- - - Updated - - -

Quote:

---

Originally Posted by Bryce

Quote:

---

Originally Posted by roy_bates

here you go.:) please excuse the crudeness of drawing it was done in a hurry,lol
http://www.amibay.com/attachment.php...1&d=1420416678

if anyone else knows different please comment:)

---

Hey, is that "RoyCAD 10.3" you've used there? :D

Bryce.

---

yes,i wish it was that wonderful:lol: comes complete with typos,it must be still in alpha:lol:

wonderful stuff here! thanks Roy for the infos :-)
the hardest part though is to find a CM14 available nowadays. a pity that is :-(