Vampire 600 V2 - Amiga 600 FPGA accelerator Pre-order

@Majsta: that's an interesting contest, I hope you win. :thumbsup:

Maybe add some new promotional pictures of the Vampire card in action to your original post on your website. It's better to make it as easy as possible for the jury.


Short question about the Vampire Black Edition, did I understood correctly the normal version has a Cyclone III FPGA ending with C8N and the Black Edition ends with C6N?
Is this the only difference or are the more differences?
Attachment 111569

PS: Vampire 500 v2 for sale: http://www.ebay.ca/itm/322249615287

Waiting patienly, it is so nice to see these Vampires with their amazing performance! :)


Enviado desde mi iPhone utilizando Tapatalk

Quote:

---

Originally Posted by CrazyBob

Short question about the Vampire Black Edition, did I understood correctly the normal version has a Cyclone III FPGA ending with C8N and the Black Edition ends with C6N?

---

C6N should in general be able to perform a little better, however this is not guaranteed and some 8s might run at speeds where most 6s cannot. The black editions can have either C6 or C8 chips as far as I understand, but they have all been verified to run at the advertised speed. The effective speed also depend on the memory on the board and not all memory chips can run at the high speed.

Well. What can I say. I played a few games last night! Geoff Crammond F1 is amazingly smooth, as is Frontier ;) a great card. The little 600 has just become my main Amiga.

Received mine today, tested so far with my amiga 1200 amikit real setup compactflash card, work buts need to make new hdd setup for vampire with all its drivers etc

@demolition: thx for the info :thumbsup:

Quote:

---

Originally Posted by CraigsBar

Well. What can I say. I played a few games last night! Geoff Crammond F1 is amazingly smooth, as is Frontier ;) a great card. The little 600 has just become my main Amiga.

---

Nice report, can't freaking wait!

Card received today and is working! Unbelievable piece of hardware. However, took me 3h with sand paper and screwdriver to get it working. Important hint from kipper2k was the right screw should not be fully screwed in, otherwise the board bends and (or least for me) is only beeping but not working. Is that normal? Or does my board have cold soldered connections?

Hi, Thursday 8 I have received the card, it works perfectly.

Thanks a lot !

Just tested buggy boy this morning. Damn that runs fast lol. The seconds fly past but you only need to use hi gear. ;)