Hi.
I have the Catweasel zorro II, which comes with 3 non bootable Buddha IDE port.
I have installed all the Buddha software from teh original floppy.
However, i am unable to use any IDE device so far.
I have tried an IDE Disk on Module, a 160 GB IDE drive and a 4GB drive that is already amiga SFS formatted.
None is seen on the WB and nothing is seen in HDToolBox.
I am afraid to have fried the board when i first connected the disk on module upside down (pin 1 was not marked). The board is seen as working in the early startup and is detected by BuddhaSpeed in WBStartup.
In 2005, i used this board with a racked 80 GB HD, but i can't remember how i did it.
I do not have the manual anymore unfortunately.
Thanks for your help.
I have the Catweasel zorro II, which comes with 3 non bootable Buddha IDE port.
I have installed all the Buddha software from teh original floppy.
However, i am unable to use any IDE device so far.
I have tried an IDE Disk on Module, a 160 GB IDE drive and a 4GB drive that is already amiga SFS formatted.
None is seen on the WB and nothing is seen in HDToolBox.
I am afraid to have fried the board when i first connected the disk on module upside down (pin 1 was not marked). The board is seen as working in the early startup and is detected by BuddhaSpeed in WBStartup.
In 2005, i used this board with a racked 80 GB HD, but i can't remember how i did it.
I do not have the manual anymore unfortunately.
Thanks for your help.