Reflowed denise, still got a blue cast.
Denise seems to be misaligned front to back about a third of a pin width - so my theory is that potentially some pins could be getting bridged.
Here's the sequence of events:
Board arrived, would not stay clipped on.
Sanded board and it stayed on - image was perfect.
Decided to downgrade the 32gb micro SD for a spare 1gb card I have laying about.
Machine now exhibiting blue tinge - from HDMI & from the RGB port.
Reflowed Denise, & kaptan taped the left and right side to avoid the PLCC pins contacting the pcb inadvertently - still blue tinge.
Any suggestions?
Denise seems to be misaligned front to back about a third of a pin width - so my theory is that potentially some pins could be getting bridged.
Here's the sequence of events:
Board arrived, would not stay clipped on.
Sanded board and it stayed on - image was perfect.
Decided to downgrade the 32gb micro SD for a spare 1gb card I have laying about.
Machine now exhibiting blue tinge - from HDMI & from the RGB port.
Reflowed Denise, & kaptan taped the left and right side to avoid the PLCC pins contacting the pcb inadvertently - still blue tinge.
Any suggestions?
Last edited: