Nathanieltolbert
Active member
Hello everyone, I have a strange issue today. I followed the guide here on configuring SFS for installation on a hard file, and applied that to a normal disk drive and after installing everything and trying to run a benchmark using sysspeed, I get this error DH0 has a blockid error in block 803. Expected was blockid 0x42E4443 but the block says it is blockid 0x4F424A43. I can reread or cancel it basically just locks hard at this point. Any pointers? There isn't anything important on this drive so if it needs to be formatted and done again that isn't an issue. If there is any other information you need, please let me know and I will do my best to provide it.
