Closed CyberStorm PPC accelerator card - 366mhz PPC / 50mhz 68060 + 128mb RAM + SCSI

  • Thread starter Thread starter Astral
  • Start date Start date
  • Replies Replies 5
  • Views Views 3102
Status
Not open for further replies.

Astral

Active member
AmiBayer
Rating - 100%
47   0   0
Joined
Jan 10, 2009
Posts
1,176
Country
NSW Australia
I've got a CyberStorm PPC card here to sell. I'm pretty sure most Amigans know what these are - so I won't blab on :)

This one works fine - except there is one problem. You can see in the closeup photo of the onboard expansion connector. One of the pins is half broken out (it's the fifth pin in heading to the left from the halfway point of the connector on the bottom row). Once I noticed this I did not plug anything into that connector, so don't know if it will be a problem or not if something is connected there. I did contact Stachu who stated that he is able to replace the whole connector. But, realistically the only time that connector is used is for the ultra rare G-Rex or for the CyberVisionPPC - the most practical solution is to forget those and just get a Mediator and cards instead. Just so we are clear - it is not the main motherboard connector, but the expansion connector that has this problem.

This one has the PPC side clocked at 366mhz and the 68060 side clocked at 50mhz. 128mb of RAM is included. The onboard ultrawide SCSI works fine too.







For this item I'd like $1700aus firm. So all up $1813aus for this card, fully value insured/registered, and PayPal fees covered, if the buyer is in Australia. Or $1905aus all up for the card, fully value insured/tracked, and PayPal fees covered, if the buyer is from overseas. The totals can be made *significantly* cheaper if...long story made short...as this has been discussed countless times here on AmiBay...alternative payment methods are used such as PayPal gift or bank transfer. I have had to choose expensive methods due to a recent eBay/PayPal bumhole re-arrangement operation (to put it politely) :lol:
 
Last edited:
Status
Not open for further replies.
Back
Top Bottom