Help needed with AmigaOS 3.9 and BB2 installation

[Templar]

Ahoy, I have a little problem with AmigaOS 3.9 BB2 installation. Yes, I feel a little bit rusty, it was a long way back when I had an A4000 again, so here is my problem.

I've installed AmigaOS 3.9 and BB1 successfully, but when I installed BB2 the CD-ROM drive doesn't work. Actually what's the catch with the Amiga ROM Update of BB2? If I don't install it, then the Amiga doesn't boot into Workbench, but if I install it, although it boots to Workbench, but a message appears "Cannot find scsi.device unit 1". As I said, before the CD-ROM was working as normal (didn't change any settings for it).

Any ideas how to fix it? Thanks in advance.

 

[trixster]

Perhaps change the CD-ROM to device 0 and then reboot?

 

[Templar]

Unit 0 is the hard disk.

 

[JLPedro]

If I recall after instaled the BBD2 the scsi.device needed to be replaced in Devs: and on startup.sequence the setpatch SKIPROMMODULES "scsi.device" QUIET, I used scsi.device v43.46 from Cosmos.

 

[Templar]

Hi Jorge, I remembered what I've done ages ago again, when I had an A4000D, and I managed to install the latest scsi.device. But now I have another problem with CyberGraphX 4. Whatever maximum khz I choose in the installation, I always get a blank screen or "Out of Range" message on reboot. I even tried with the latest version found on Aminet but to no avail.