Closed Not working CyberStormMKIII or CyberStormPPC

Status
Not open for further replies.

Cosmos

New member
Banned
Rating - 99.1%
111   1   0
Joined
May 15, 2009
Posts
395
Country
France
Region
Besançon
Looking for an HS CyberStormMKIII or PPC to desolder the Mach231

It's for repair my CS !


Thanks a lot,
 
Last edited:

Kin Hell

Active member
Banned
Rating - 100%
48   0   0
Joined
Nov 25, 2007
Posts
6,970
Country
U.K.
Region
Cornwall
Do you have any knowledge about how the Mach231 chip fractured like that?

Kin
 

stachu100

Active member
Rating - 100%
385   0   1
Joined
Aug 31, 2009
Posts
2,906
Country
Poland
Region
mazowieckie
Non-working Cyberstorm might have dead MACH IC's, but I'm sure you know that. ;)
Good luck with repair!

P.S.
I just noted that plastic case on this MACH was deformed - it means that silicone inside was VERY hot (5V instead of 3,3V???).
 

FLOPS

New member
Rating - 100%
61   0   0
Joined
May 17, 2010
Posts
338
Country
Poland
Region
Silesia, near Czestochowa
CS MKIII

CS MKIII

Hi,

I have working CS MKIII formerly CS PPC. Maybe are you interested? I'm sending PM.
 

Cosmos

New member
Banned
Rating - 99.1%
111   1   0
Joined
May 15, 2009
Posts
395
Country
France
Region
Besançon
The BlizzardPPC have a Mach231 too...

It's the same .jed into than the one in the MKIII ??


Good question, isn't it ?!
 

stachu100

Active member
Rating - 100%
385   0   1
Joined
Aug 31, 2009
Posts
2,906
Country
Poland
Region
mazowieckie
As you will not get ANY support from DCE, there is only ONE way to get an answer. :)
 

Cosmos

New member
Banned
Rating - 99.1%
111   1   0
Joined
May 15, 2009
Posts
395
Country
France
Region
Besançon
Still looking for !

Of course, I'm ok to give some money for this not-working board...
 

FoX

New member
Rating - 0%
0   0   0
Joined
Sep 3, 2010
Posts
4
Country
France
Region
LA
Hi Cosmos.

Any news on repairing this one ?
Anyone with a chip reader wanna dump this Mach231 ?

Good luck mate, and keep up the good work on your amazing blog ;)
 

Cosmos

New member
Banned
Rating - 99.1%
111   1   0
Joined
May 15, 2009
Posts
395
Country
France
Region
Besançon
>Any news on repairing this one ?

Still looking for...


>Anyone with a chip reader wanna dump this Mach231 ?

My Wellon programmator don't accept Mach ICs...


>Good luck mate, and keep up the good work on your amazing blog

I have many many new ideas...
 
Status
Not open for further replies.
Top Bottom