Sold SD2IEC for Commodore 8 bit systems

  • Thread starter Thread starter TheCorfiot
  • Start date Start date
  • Replies Replies 34
  • Views Views 5481
Status
Not open for further replies.

TheCorfiot

Out in the Wild
VIP
Rating - 100%
232   0   0
Joined
Mar 28, 2008
Posts
8,697
Country
Greece
Region
Corfu
Hello Chummies

I have built a batch of 6 SD2IEC Interfaces...

Fully tested with Commodore & JiffyDOS Kernal Machines..

Complete with Wired 6 Pin Serial Connector, just need connection for power +5V DC

Price each £35UKP includes shipping to UK, for EU add extra £4

Paypal gift payment of buyer pays fees please.

Perfect Christmas Stocking fillers. :)

TC :)

1 Sold to LTAC
1 Sold to Tomse
1 Sold to Chinners
1 Sold to adsboel
1 Sold to danielj
1 Sold to Twip in wanted thread
All Sold
 

Attachments

  • DSC00130.jpg
    DSC00130.jpg
    193.1 KB · Views: 3
Last edited:
Hi mate,

Please, my questions:
- are you supplying the schematic to locate the power +5V DC on the CBM64 motherboard?
- this SD2IEC Interface is also compatible with C128D or not.
- have you some pics to show how install it inside the CBM64?

Thanks! :thumbsup:
 
Last edited:
It's very easy to install internally, and indeed it's compatible with C128D, you will need to change the internal drive id which again is very easy...

Also compatible with Vic20,C16 and plus4.

I can certainly knock up some install pictures for you.

TC :)
 
Fine!
Thanks!
So Declaring interest for one unit please!

I'm looking for the most simple and clean method to make a hole on the CBM64 case and a non-complicate installation! :D
 
The best place to fit is on top of the RF convertor using insulating double sided tape.

For the slot, just take your time and use a sharp craft knife to slowly score the cutout until you go deeper and deeper.

If you are planning on installing this internally then I can remove the DIN plug and strip and tin the individual wires carefully labelling them individually and a picture of the pcb with the attach points...

I will send you a PM with payment details and will post It out straight after christmas as we have missed the last post now.

Regards TC :)
 
Payment received from LTAC too :thumbsup:

Will ship the units out to Tomse, Chinners and LTAC tomorrow.

Thx guys
;)
 
Last edited:
Received today... :thumbsup:

thanks alot, and left feedback :-)
 
Last edited:
Status
Not open for further replies.
Back
Top Bottom