Built 2 Z3660 cards with help from JLCPCB but I need only one for myself. So this 2nd card is for sale, it's been fully tested with both zTurn and real 68LC060 CPU.
It has following features:
- ARM FPGA or 68060 CPU
- 128MB CPU RAM (DMA), 256MB Z3 RAM (no DMA)
- AHI and MHI Audio
- RTG 16bit...
I started to tinker with my 'new' S3ViRGE/DX card. It also needs different openpci.library by THOR etc. I'll just link here how it's going (not working yet)
https://www.a1k.org/forum/index.php?threads/68991/page-62#post-1803308
(I don't have graphics card installed yet, but USB doesn't need DMA, right?)
Did you solve this? Currently, I'm on the same boat. Same error with both OpenUSB.device and PrometheusUSB.device:
I get these lines, so the card is found:
Welcome unit 0 - Type 'OHCI Host Controller'
Name: 'NEC uPD...
Let's see in a few days. Found this nice little shop from Czech who stock some S3 cards for a reasonable price among other goodies. https://dsmcz.com/prestashop/en/
Thanks for confirming this, another lesson learned.
Found elsewhere, that even S3 Virge / Trio cards would work. I think I'll hunt for those too, they don't cost arm, leg and two souls.
Now I got the cannot allocate 44kByted of DMA memory error with rtl8139, but my setup differs a bit.
A4k + Firebird (Hese) + Cybervision 64/3D in Zorro slot. I have DMAsize=2048k in tooltypes and monitor file renamed to Prometheus. RTG itself works.
So does the RTG card need to be PCI card for...
All of above solved. It was multiple problems, but the main culprit sits between the chair and soldering station.
Buster socket had couple bad contact pins, added some solder too. And the final reason was, 1 pin of resistor network was no contact on firebird and other one had small solder...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.