Recent content by scoca

I seem to have made it work by using an older version on WinUAE. Version 4.0.1 Thanks for the replies.

This is what I get after selecting Save Changes to Drive and re-booting.

Hi, After following a few tutorials, including one on here, I still can't get the partitions to appear on WINUAEs Workbench. I think I've done it all correctly, Diskpart, WinUAE as Admin, PFS3AIO, MaxTransfer set, HDD set to IDE(auto) etc. The card worked when I removed it, I just wanted a...

Nostalgia always brings me back to Menace.

Not that close, I'm near Scunthorpe.

I haven't tried a new CF card. I have the old mechanical HDD I can try. Yes, booting from FDD and test is ok. Max transfer is 0x1fe00. Is it worth me downloading an anti-virus?

- - - Updated - - - Just to clarify for me, if you remove the hard drive and run the ram test again, will it give errors? or is it only when the hard drive is plugged in?? Running the memory test without the hd and there are no errors yet.

- - - Updated - - - Just to clarify for me, if you remove the hard drive and run the ram test again, will it give errors? or is it only when the hard drive is plugged in?? I'll check this later today, thanks. - - - Updated - - - I'd like to try this but I don't know anyone else with an...

Errors have appeared, can anyone tell me what to do now?

The testing is ongoing. I tested with chip ram only - PASSED. Tested with chip and fast - PASSED. I plugged in the compact flash hd, loaded the test program and it crashed. So, using the bit by bit method mentioned above I changed 1 thing, the ribbon cable from the motherboard to the CF...

I didn't realise it needed such a long test, but no problem, I'll run it again with no ram card, hard disk or compact flash for at least 24 hours. Thanks again.

I've let the analyser run for a while and no errors, lock-ups or re-boots. - - - Updated - - - Running it again now with the fast ram installed. - - - Updated - - - Fast RAM ok.

I'll try booting without the ram card later today. I've photographed the motherboard so maybe someone could tell if it's re-capped. I appreciate all this help

No shades of grey at all. Black screen then workbench. - - - Updated - - - Using it now and it locked up and screen went blue.

I've just looked and it says it's an A500 power supply, I've no way to check the voltages, I'll have to borrow a multimeter. There's an 8MB expansion card from AmiKit and a PCMCIA CF card.