Recent content by SM1WZV

Do you have any good quality picture of the cards both sides, this so we do not need to guess. Also there are a factory repair wire on the backside of the card, than can give black boot screen if absent when trying to boot from 68k CPU but the card will operate when using 030-CPU. Do note some...

Hello All I´m in need of the software disk to a Cameron Handy scanner type 10.1 for Amiga, got the hardware but it useless without software :-( Been searching the Internet without no luck, all I can find are pictures of the unit at BBoAH and many other URLs, at amiga.resource.cx I go the...

Hi you might need to check if FPU are using its own clock, J2 jumper on pin 1-2 change if sharing the CPU clock, my board do not like brutal overclocked FPU, 25MHz unit trying to run at 40MHz... it gives black screen and no boot. You can olso try to place an jumper on J1 to force the board to...

Glad to give you some help.

Make new holes i gotek plastic and you are on the track again. If you have the 1/2HE origin floppy and try to mount the gotek below it. Then you need to remove a large chunk of plastic from the gotek hausing, to make it allign with front plastic. This due to design of A4000 front plastic and...

Hi, the device_test function needs a 5V serial connection to pin1 and pin2 on the Arduino board for receive and show any diagnostic information. There re a minor fault i noticed in the plipbox interface design. When your Amiga needs to perform an restart for some configurations needs, the...

You can clock the CPU at 50MHz or higher if your board have a separate curcuit for the FPU. My revision 3 board have 33MHz clock ticking a 25MHz marked FPU while a 60MHz clock are feeding rest of the board and over clocking an 40MHz CPU. So it all depens on board design, CPU and FPU ability to...

I found his old selling post and answered to it some waiting later we managed to make a deal in that thread so my search was over thus rendering this thread obsolete. I have given him ratings according to his selling post, not seen any ratings back yet.

Found a complete VXL turbocard including the RAM32 card from member highend.

Card received in described condition.

Off topic but, I have pinouts for power connection if any of you speculants are interested.

Sell did response to my PM so payment sent, waiting for delivery...

My A2000 did lose its HDD content and after many thouth and tries ending with SCSI bus lockups. Finaly discovered That my Aztec-II will not accept any more units on the SCSI bus. Tried it together with another HDD, CD and Tape drive same lockup but if the Aztec-II are the only unit attached - no...

Nice you find the fault. Did forget to hint about cable allingment sins Gotek PCB have a silkscreen where pin 2 and 34 are showen at both ends of the floppy connector.... Happy Amiga time ;)

Is the Gotek working correct when placed as external I.E. assigning slots, reading&writing to slots? If so then the DF0 swap or early boot selection should work as intended. You might need to jump S1 insted of S0 when Gotek is connected as external. Hope this will help you solve the problem.