Recent content by Tom-Cat

Actually on this forum the admins are defacto Gods. I'm not sure you read every post in this thread, but according to what happened, people should not trust their judgment when it comes to security issues like that. To repeat what I read above: an admin explicitly confirmed that the seller's...

You implied that it's normal for admins to make such mistakes, and it is not their fault when situations like this happen.

Are you implying that we shouldn't trust admins here anymore?

Hi. Does the RGB cable for Ultimate 64 connect all 8 pins (also pin 8 - Fast Switching) ?

Declaring interest for Angry Space Invader joystick interface only.. if for some reason both don't go in one lot.

As amibuyer said... I will stop after this post. I will send the unit back to kisiel to fix it, no problem. But I don't want a refund, I want a working unit back - either my unit fixed or another working unit, I will even pay for postage, no problem. I like the device a lot and all I did was...

The REFUND part is wrong. I want the device. I don't want to loose the device just because there is something wrong with it. If you refund me the money and I send you the device back I won't have the device anymore. It is not like I can just buy a new one in a week. Normal practice is either to...

Kisiel, your attitude towards paying customers that do their best to give bug reports is really bad. If you want I can send you my UK1541 back in a week or two, but I would like a replacement or a fixed unit back and not a full refund.

If you say so. But I haven't had a SINGLE problem with IR prior to this firmware update. Also the IR works fine for everything. The "select" button stops working after the Unmount sometimes. ALWAYS after I unmount the image (which Select button is needed to do and works upto that point). Also...

I am not claiming anything about any SDcore reset? And where did I say I press and hold reset button for core6502 and press button on pcb ? These are the problems I reported: 1. The "select" button (2nd row 2nd button) on the remote control stops working "randomly" but always after I press it...

What ? Everything worked fine before this SD core update... not sure why this would be a hardware error. I am 100% sure this is a firmware bug and not a hardware error. Before this update I have never had a problem with the "fire" button, it stops working randomly, but ALWAYS after I UNMOUNT an...

If I press the RESET on the UK1541 (right button) then it resets and freezes on the text screen (it never gets into the browser)... I have to turn off the c64 for a few seconds and on again to make it work again. This is of course only if I make it "freeze" with the remote control core reset...

Thanks Kisiel. Fragmentation problem seems to be fixed now. Unfortunetly there seems to be a problem with the "Core Reset" button of the remote control (the most up right button on the remote). Sometimes it works, but most of the times it just freezes up UK1541 and it doesn't work anymore (you...

Update never happend... I got the File Check... message the first time i turned on the c64 with the firmware update on the SD card.

Hello kisiel. When I try flashing this new firmware my UK1541 always stays on the "File Check..." message and it does not go beyond - it does not flash the device ! What is wrong ? It worked fine with all other previous firmwares.