Listing up a lot of parts I'm going to see off to a new home. I'm restoring/upgrading my 2000 that I pulled out of the basement and heading in a new direction with it. Up for sale are the following:
2088 XT bridgeboard with a ram expansion board and floppy drive/cable. I haven't used this in a while, but I did plug it in and it shows up in the devices. I don't know the condition of the ram expansion board though, it does have some corrosion on it here and there. I sprayed it down with deoxit in any case. Consider the memory card a freebee. I don't have any 5.25 floppys to try either, so I never bothered with trying to setup any of the software.
<Snip> $200 obo.
SOLD on ebay
Next up is a GVP Spectrum 28/24 video card.
https://amiga.resource.cx/exp/egs28
I don't have the cable to pass the native graphics through to the card. Not sure where it ended up. I do however have a DB23 to SVGA cable I bought (non-buffered) that I thought I could use with my monitor to view the amiga. Turned out I needed a buffered adapter. So you can use this one with a easily found DB9 connector to make up your own pass through cable. It is detected by the system as well. No further testing done. $250
SOLD EBAY
Next up is the Kipper2K romulator. I will toss in a 4gb SD card with diagrom loaded on it. It works well on a stock machine, but seems to be problematic with my accelerator card. Other cards apparently work well with it like the terrible fire cards. It's a nice piece of kit, but if you have a megachip installed, you'll need to stack sockets to make it all clear. This can be used also in A500's. And I believe later model amigas since it has the additional pins. Amiga on the lakes sells them, but it seems they're difficult to catch in stock. $80
SOLD ON EBAY
https://amigaonthelake.com/romulator-for-the-amiga-500-2000/
Next up is a DKB rom switcher. I honestly know very little about this device. It came with the amiga, but wasn't installed when I got it. I haven't tested it. Comes with official Commodore 1.2 and 2.05 roms. $40
Lastly, I believe this is a DF0/DF1 switcher to switch their priority. It was installed in my system. But I've gone to just a single gotek. I'm also unsure of this device since my drives won't read (sound horrible, hence the gotek) $10 SOLD off facebook
System without any cards installed just to show for the record:
2088 XT bridgeboard with a ram expansion board and floppy drive/cable. I haven't used this in a while, but I did plug it in and it shows up in the devices. I don't know the condition of the ram expansion board though, it does have some corrosion on it here and there. I sprayed it down with deoxit in any case. Consider the memory card a freebee. I don't have any 5.25 floppys to try either, so I never bothered with trying to setup any of the software.
<Snip> $200 obo.
SOLD on ebay
Next up is a GVP Spectrum 28/24 video card.
https://amiga.resource.cx/exp/egs28
I don't have the cable to pass the native graphics through to the card. Not sure where it ended up. I do however have a DB23 to SVGA cable I bought (non-buffered) that I thought I could use with my monitor to view the amiga. Turned out I needed a buffered adapter. So you can use this one with a easily found DB9 connector to make up your own pass through cable. It is detected by the system as well. No further testing done. $250
SOLD EBAY
Next up is the Kipper2K romulator. I will toss in a 4gb SD card with diagrom loaded on it. It works well on a stock machine, but seems to be problematic with my accelerator card. Other cards apparently work well with it like the terrible fire cards. It's a nice piece of kit, but if you have a megachip installed, you'll need to stack sockets to make it all clear. This can be used also in A500's. And I believe later model amigas since it has the additional pins. Amiga on the lakes sells them, but it seems they're difficult to catch in stock. $80
SOLD ON EBAY
https://amigaonthelake.com/romulator-for-the-amiga-500-2000/
Next up is a DKB rom switcher. I honestly know very little about this device. It came with the amiga, but wasn't installed when I got it. I haven't tested it. Comes with official Commodore 1.2 and 2.05 roms. $40
Lastly, I believe this is a DF0/DF1 switcher to switch their priority. It was installed in my system. But I've gone to just a single gotek. I'm also unsure of this device since my drives won't read (sound horrible, hence the gotek) $10 SOLD off facebook
System without any cards installed just to show for the record:
Last edited:
