23 pin to 9 pin video cable schematic

[Memphis]

I'm looking for rgb Cable schematic for 23pin female to 9pin male, so i can hook up my C2002 Monitor.

:roll:

 

[johnim]

i dont know if this will help
http://www.rabayjr.com/amiga_portas.htm

 

[salaxi54]

Not sure about the 2002 monitor, but i'd make a wild guess that it should be the same pinout as the 1080 and 1084 D-sub connector.
Bearing that in mind, this should be the one side: http://pinouts.ru/Video/C1084dd_pinout.shtml
And this should be the other end: http://pinouts.ru/Video/AmigaVideo_pinout.shtml
Other than that, i believe that you should chose either the analog or the digital lines for what you want to make..

 

[rkauer]

The C= 2002 uses the very same cable as other 1084S and variants.

Nobody in the sane conscience will use RGB-digital (aka CGA) colour scheme: only 8 colours (four are half-bright).:computertrash:

 

[Memphis]

what would be the best to get nice picture out? i know this monitor was made for C 1000 and 128 ;/

The C= 2002 uses the very same cable as other 1084S and variants.

Nobody in the sane conscience will use RGB-digital (aka CGA) colour scheme: only 8 colours (four are half-bright).:computertrash:

 

[thgill]

Just get a RGB cable for a 1084.

However, make sure the connector on the cable matches the back of the monitor while most of them used 9 pin connectors, some cables also might have round 6 pin connectors as well since some 1084 variants used that. Also make sure if the connector needs to be male or female.

If you have the monitor in your possession, its easy to tell which you need.

 

[Memphis]

yep, thanks