For Sale AMIGA Over voltage protector V2.0 - Exclusive edition -
- Thread starter axel81
- Start date
- Replies 76
- Views 8215
Why not all lights off (or on) if there’s a faulty (or ok).
This way the product would be easier to read
the product could even have it written like “led on means error”
It’s only a suggestion
I’m interested to buy one
This way the product would be easier to read
the product could even have it written like “led on means error”
It’s only a suggestion
I’m interested to buy one
finally got around to trying this out on my 1200 Tower and I've got only green & yellow lights on so power is on but no boot...1st post says if there's no White or Blue LED there's a problem?
Question is the only thing I did was connect this power saver? I measured the voltage on the +12 and it read 12.18v with no load and -11.49.
Are these safe loads? is it possible my PSU all of a sudden went bad?
Question is the only thing I did was connect this power saver? I measured the voltage on the +12 and it read 12.18v with no load and -11.49.
Are these safe loads? is it possible my PSU all of a sudden went bad?
