Warning: This thread is a bit long picture wise!
This has been a long time coming. I always over think everything by fussing over the correct parts and always keep an eye out for that special bit that can solve a problem. So after way too long I have finally mounted an HxC2001 into an A500+. It was trial fit at first and it went better than I expected. It may not look much, but it is tidy and that is what I wanted
I have a new almost mint case for the A500+ to fit sometime soon and I need to Retrobrite the Eject button I used. The eject button was from an old dead Chinon A500 drive.
---
At a later date I will attempt to fit the display screen and work out a way of fitting some nice buttons for diskchange etc.
This has been a long time coming. I always over think everything by fussing over the correct parts and always keep an eye out for that special bit that can solve a problem. So after way too long I have finally mounted an HxC2001 into an A500+. It was trial fit at first and it went better than I expected. It may not look much, but it is tidy and that is what I wanted
I have a new almost mint case for the A500+ to fit sometime soon and I need to Retrobrite the Eject button I used. The eject button was from an old dead Chinon A500 drive.
---
At a later date I will attempt to fit the display screen and work out a way of fitting some nice buttons for diskchange etc.
Last edited:
