Found C64 Mouse 1351 (housing or defective!)

[Fook42]

Hello,
as i have one mouse that is working but the upper cover is broken, i am searching for a new housing for it.
please offer any mouse that you have (as long as the upper cover is okay) - dont need the cable either.

thank you.

 

[Deleted member 14264]

AFAIK, the 1351 has the same cover as the original Amiga mouse provided with the Amiga 500, 1000, 2000 and 2500.

It would be much easier to find what you look for in the Amiga section.

 

[Fook42]

thanks for that hint!..
i have an AMIGA-Mouse here, but the cover does not fit - the buttons as slightly different as the the switches are placed on the main-PCB directly.

maybe an old (!) AMIGA-Mouse (from the Amiga 1000) will fit, but its hard to get one of these either.
-> but if anyone has one - please contact me!

 

[Deleted member 14264]

thanks for that hint!..
i have an AMIGA-Mouse here, but the cover does not fit - the buttons as slightly different as the the switches are placed on the main-PCB directly.

maybe an old (!) AMIGA-Mouse (from the Amiga 1000) will fit, but its hard to get one of these either.
-> but if anyone has one - please contact me!

Amiga mice with board A0101930 which were made up until 1987 have the same type of "daughterboard" buttons as the 1351.

These were provided with early Amiga 500, 2000 and 2500.

See: http://www.the-liberator.net/site-f...-amiga-mouse-pushbutton-012-compare-plugs.JPG

Board A0101910 is the board of a 1351 mouse.

This guide of various Amiga mouse revision can help:
https://www.amibay.com/showthread.php?42514-Tank-mouse-revisions

Amiga 1000 mouse have the "elbow" connector and I have no idea what's inside.

 

[twinpeaks]

please offer any mouse that you have (as long as the upper cover is okay) - dont need the cable either.

Hi,
I might have what you want. A 1351 housing where I ripped out the electronics already. The case is mechanically OK but badly yellowed.

Will send you PM.

 

[Fook42]

looks great!
here are 2 pictures of the buttons inside - i hope your cover fits to these buttons

 

[twinpeaks]

It doesn't fit out of the box but I think that it can made be fit.

Here is a comparision of the two different 1351 versions I have. The left cover is from a model with buttons as in your mouse. The right cover is the one that I have for sale and this has these "clicker" type buttons (just a round blank metal sheet).



If you carefully file down these plastic posts that go down to the buttons, it should work. I can see no other difference.
But also interesting, that your model looks different to mine two, so there are even at least three versions of the plastic cover.

Another idea, maybe you could swap the plastic inset from your broken cover to mine.

 

[Fook42]

PMs answered and payment sent...

 

[twinpeaks]

Shipped.

 

[Fook42]

received! .. thank you very much!