External drive interface to place a Gotek on DF1: & a PC Drive on DF2:
or just a PC Drive on df1: You can also put a Gotek on DF1: by itself but nothing on the PC drive end Its' a very particular interface. Gotek works on the middle cord connector but the end connector is only for a PC drive.
I had a Toshiba nd-3564gr(like a Chinon FZ-357).
Sold outside Amibay.
Now $8.99 USD plus S&H.
Pay via paypal (family/friend)
Please PM for shipping costs to your country and state your interest here too!
Gotek/Pc Drive can be also connected alone either directly to amiga,
or chained connected to external drive(s)!
(note: Gotek drive must have the appropriate firmware for amiga, either Cortex , Hxc or FlashFloppy )
Use the 2 small switches to Select Drive order!
This could be VERY useful, if you also have a Drive Boot Selector installed,
In order to Boot from either a Gotek/HxC Drive or a PC floppy Drive!- The cable might work with other floppy emulators too (for example HxC floppy Emu) but i can't guarantee it will do so.
- If you are using HD 3.5" disks along with a pc floppy drive connected to amiga, be sure to cover the HD hole of the disk with a little duct tape in order to enable pc drive's DD/720Kb operation mode.
- Although the adapter is tested with many 3.5" PC floppy drives,i can't guarantee that it will work with every 3.5" floppy drive existing.
Last edited:
