Found Standoff screws for Amiga 2000 floppy drive
- Thread starter fabbie54
- Start date
- Replies 10
- Views 2041
- Status
Most of my A2000s have the Brass/Aluminium spacers but at least one simply has longer screws with round nylon spacers (non threaded). I think it’s also possible to raise the tray (second set of mounting cutouts on the sides, if I remember correctly) -> doesn’t require spacers.
Last edited:
Yes, that's those I mean. Are they standard standoff screws?
(sorry for the late reply, I didn't notice someone had replied)
Yes these are ones like I found on one of my drive's.
But be aware that they differ quite a bit from drive to drive, that is why I asked about the height (some drives sit higher/lower then others).
But be aware that they differ quite a bit from drive to drive, that is why I asked about the height (some drives sit higher/lower then others).
Hi, I just bought this pack - its only a few pounds
https://www.ebay.co.uk/p/Pack-228pc...-Notebook-UK/507960069?_trksid=p2047675.l2644
It has some stand offs in here. They are not an exact match, a little smaller but I have fitted my PC 1.44mb drive to my Bridgeboard on the A2000 mounting plate. It is good enough for the purpose, and maybe worth a shot for you too.
Cheers!
https://www.ebay.co.uk/p/Pack-228pc...-Notebook-UK/507960069?_trksid=p2047675.l2644
It has some stand offs in here. They are not an exact match, a little smaller but I have fitted my PC 1.44mb drive to my Bridgeboard on the A2000 mounting plate. It is good enough for the purpose, and maybe worth a shot for you too.
Cheers!
I am interested! PM sent.
- Status
