Sold Z-500 A500/A500+ Zorro II adaptor

[darefail]

For sale this adaptor which allows you to connect a Zorro-II device to the sidecar port of your Amiga 500 or 500+, allowing the use of RAM cards, IDE controllers, SCSI controllers graphics cards and so on. It is known to work with:

A2058 Zorro RAM card
A2091 RAM / SCSI controller
Buddha Catweasel Z2 IDE controller
GBAP II++ graphics card
ZZ9000 graphics/network/USB combo card
Multiface 3 Card
A590 hard drive/RAM sidecar

An optional power connector is provided on the board to allow additional power for power-hungry devices. This must be from the same PSU that powers the Amiga. It is rarely required however.

Please read the instructions attached.

I am asking 40€ plus shipping (Paypal F&F)

Thanks

 

[Timtheloon]

Declaring interest.

can you confirm this allows you to still connect a side car?

 

[Skyrunner]

Declaring interest.

 

[darefail]

Declaring interest.

can you confirm this allows you to still connect a side car?

Maybe @Hirsch @Szmn and @AwakeningStar may help with that.
I have only used it along with an Ashcom Addax memory sidecar.

Edit: read troubleshooting 3rd dot. ACA500+ is working but maybe not with an accelerator on it. Depends on autoconfig or DMA clashes of the device you are going to use.

 

[Timtheloon]

Payment Sent

 

[darefail]

Payment Sent

Received.
I'll try to post it tomorrow.
Thanks.

 

[Hirsch]

In theory the side car should work with this adapter. I've still a project pending to populate an A500+ with an E-Matrix 530, a GBAPII++, this gem of an adapter and a 3D-printed side car case. Unfortunately, time is the limiting factor for me. (First step will be recapping the A500+.) I can give an update here once I succeed with the project, but don't expect it too soon.

 

[Timtheloon]

Adapter arrived done some minor testing to see if will play with my side car and looks good so far

it does make the miggy a bit to long for my desk but once I win the lottery and build my super man cave it will fit perfectly