Recent content by cevoner

reduced price.

The Terrible Fire TF1260 implements 128MB of Fast RAM, a fast IDE interface, and a socket for a Motorola 68060 processor. Comes with a MC68LC060 clocked at 50Mhz (higher frequencies can be selected by software.) PayPal was $399.00 now only 379.00 USD plus S&H. Perfect condition. Added heat...

Package mailed. Thanks.

The A1200/600 CF-IDE buffered adapter allows to connect a CF card and an additional IDE device to your Amiga 1200 or Amiga 600. It features one CF card slot, one 44pin IDE connector, a buffer for 24 IDE signals to stabilize data transfers, and also a converter to fix well known issues with the...

Another note: 1260 clock now normal with adapter removed.

Sure. Thanks again., miggymad.!

Yes it is. I just booted with 3.1 workbench, no ide and I have the Clockport back. I would have not known that the signals went to the ide too if you did not point me to that website. Thanks. What to do now? Let Amiga.eu know. They made it actually. Though it’s a great interface it sacrifices...

I bought it from Amigastore.eu. I’ll definitely try without it and see. There is a jumper which is off. No manual to speak of. I can ask them if that is the culprit.

As I said before, The PCB explorer pointed the read and write signals back to the 44 pin IDE. The clockport and IDE use the same signals. I just added an IDE board to the IDE pins for buffering my hard drives. It uses an SD card plus a ssd drive. Could that board be stealing these signals from...

Thanks for the PCB explorer link.

It worked flawlessly for years after that. I don’t believe so. I’ll check near the caps. Thanks for your suggestions. The PCB explorer pointed the read and write signals back to the ide. The clockport and ide use the same signals. I just added an ide board to the ide pins for buffering my hard...

I am about to try that soon. It could be a number of issues but that is one I will check IORD and IORW are on Gayle. They should connect to the Clockport as far as I know.

yea, I have one but it is not found. I’m told Gayle handles the signals. Something has gone dead and I can’t figure it. I found a board that offers clock signals that may work. A DIY Clockport by PCBway. It is worth a shot. May be too expensive otherwise. I can’t see how it happened. It just...

I have a 1200 that has been recapped and works great except suddenly the clock was not found. It happened after I replaced the battery in my 1260. The clock ram great for 2 weeks then suddenly failed. The clock on the 1260 is OK because it works on my other Amiga. The 1200 with the problem has...

They use to be great. Sad they are treating people this way. I have better experience with Alinea and Amigastore.eu now. They were very prompt with orders.