Amiga 1200 2B and A4000 external keyboard

[YouKnowWho]

I searched, I swear! Does someone know if running 4 pins for the 7 pin connector on the 2B to a PS2 female connector to match the A4000 keyboard pins will work?

I ask because I found the 7-pin 2B pin-out and there is no 5V noted. Cut me some slack please, I'm not an expert in electronics, is Vcc the 5V? I don't want to try without being sure and blow some keyboard controller. So...connect pin 1/2/6/7 out of those 2B 7 to a PS2 connector correctly and I can just pipe in the A4000 keyboard? What about the reset pins? Needed? Or can that be wired up to a "RESET" button somehow? If so, anyone know how?

 

[miggymad]

Vcc and Vdd are positive power voltages.

Vee and Vss are negative power voltages or are connected to ground.

Sorry, can't help any further with your project.

 

[YouKnowWho]

Vcc and Vdd are positive power voltages.

Vee and Vss are negative power voltages or are connected to ground.

Sorry, can't help any further with your project.

Thank you.

So I should put my power meter to the Vcc pin and check for 5V+. Got it.

Yes...I bought a power meter...mostly for the continuity option in case there was a trace issue on the 500+ I bought...you know the story with the batteries there I'm sure. But it turned out OK in the end. But I am high tech and can now measure voltage. I'm thinking this Vcc, if that means positive voltage probably just means the 5V+ we're looking for on these keyboard pinouts.