Wanted Amiga 1200 gotek mount

[george7272]

I just built a ReAmiga 1200 and I added a gotek drive. I got 2 slighly different gotek mount and it seems both position the usb and buttons a bit inside the floppy slot
Is there any gotek mount (for oled) that position the pcb 2-3mm further out so I can easily press the buttons?

 

[Watson]

I believe they are all the same design as far as the usb and buttons are concerned, unless of course someone has redesigned this, but not that i have seen.

 

[george7272]

I don't know if the original A1200 cases are slighly different but on my A1200.net case the gotek sits 3mm-4mm inside so it is hard for me to press the buttons
Also the OLED would be better if it is was a bit more on the left

 

[Watson]

A1200.net case the gotek sits 3mm-4mm inside

I wasn't aware of that, maybe one of the other members here can help.

 

[george7272]

The ReAmiga 1200 motherboard and the A1200.net case are fine. The last screw on the right is where it is supposed to be but the gotek mount
that is supposed to go to that screw is slight missalighed to where I wanted to be. If I push the gotek mount a bit inside so I can screw it to the mouse pcb board
this is where the buttons are inside and are hard to be pressed.
I will take some pictures and post here