Apollo 1240/60 64 mb single simm

[embedder]

Declaring interest in 1 piece

 

[r0jaws]

Definitely still interested. I'll send you a PM.

 

[Marmes]

OK!
24Hours running. Conclusions: SPLD goes to 65 degrees, it's normal due to its small size. It can go up to 85 degree. so 20 degrees is safe. If anyone wants one of these modules please contact me. I will sell them for 25 euros each plus postage and paypal fees. This is working here with no problems at all with the simms I tested (60ns, 50ns and 40ns), if you buy one and cannot put it working yourself, please contact one of many good members here in this forum eg. Stachu, RoyBates, vibros, mjnurney and so on. They sure can help you, I can do it too. This mod will work good with 4 , 16 and 64mb simms, for other simms please put it as it was. I will upload later what you must do to install it.
I am here to answer any questions.
Thanks!

 

[r0jaws]

Coolio.

 

[slyder]

Still interested... I will extend my interest to 2 pieces if available. Shipping cost to Finland?

 

[embedder]

Money sent to Marmes. Many thx!

 

[r0jaws]

Payment sent for one piece.

 

[slyder]

Payment sent for two pieces.

 

[embedder]

Received mine today. Many thx @ marmes.

But there were no instructions. Can you provide a description of the four solder pads on your PCB andwhere to solder the two wires on the 1260 to?

 

[Marmes]

Will put later with photos., only need to solder 2 wires

 

[Damion]

This has to be one of the most badass hacks I've seen in quite some time! int:

I no longer have my Apollo 1260... but I do have a 1240 sitting here waiting for the full monty.

Definitely interested in one if still available!

 

[slyder]

Will put later with photos., only need to solder 2 wires

Received two boards yesterday . Thanks.

I've got my MACH chips in their original sockets. So I guess I need to run more wires than 2, it's ok though as long as I know where I need to connect them to

 

[embedder]

So I managed to get rid of the MACH210 socket and the MACH has been soldered to the PCB diretly.
Is there a kind of a manual yet where to connect the wires to?

 

[Damion]

Got mine today, thank you

 

[Jaymz]

I'll take one for my Apollo 1260. PM´d you.

Can anyone point me in the right directio to what 64MB SIMM to get?
60ns EDO or Non EDO? NON Parity? Thanks.

 

[roy_bates]

single sided 64 mb edo or non edo should be fine,just make sure its a 5 volt simm

 

[Jaymz]

single sided 64 mb edo or non edo should be fine,just make sure its a 5 volt simm

Thanks...will head over to the other bay.

 

[Jaymz]

Payment sent for 1 board. Thanks.

 

[embedder]

Please:
Can anyone give me advice where to solder the needed two wires to?

 

[Marmes]

Tomorrow I will post pictures and instructions.